Wallet Liner Instructions by Collin Williams
|
|
|
|
1. Cut the card slots on the interior per the pattern. |
 |
|
2. Using the provided guide, mark the bottom of each card slot (vertical for vertical cards and horizontal for horizontal cards) as shown |
|
|
|
|
|
3. Using double sided tape, place a strip of tape below each card slot, above the top card slot and above the bottom slot marks as shown |
|
|
4. Remove cover from tape below first card slot and place Tyvek moving towards upper slots as shown |
|
|
5. Remove cover from tape and fold Tyvek down to cover. |
|
|
6. Remove cover from the tape below next slot and fold Tyvek back up to the next card slot, apply tape above next guideline |
|
|
7. Fold Tyvek down to cover the tape |
|
|
8. Remove cover from tape under next card slot and fold Tyvek to cover tape. |
|
|
9. Apply tape above next card slot mark and fold Tyvek down to cover tape |
|
|
10. Remove cover from tape above next card slot and fold Tyvek to cover |
|
|
11. Trim excess Tyvek from above top card slot. For vertical wallets repeat steps 7-10 until you reach the last slot |
|
