Renia 3D Embossing Filler

Ready-made Filler for 3D Embossing work. Based on leather dust, cork granulate, and a special Toluene-free binder, this product offers a quick and easy solution to all embossing needs.

Specifications

• Free of toluene and MEK.
• SHELFLIFE: Minimum 12 months at 20 °C
• thinning: can be thinned with 2000-33 Renia - Rubber Cement if it gets too dry at any point in time
  
• tip: keep the can tightly closed. Cans should be stirred before use, to ensure an even distribution of all components. (Or turn the can upside down every now and again during storage)

Instructions

• prime leather with Renia -  Rubber Cement first: 2000-33
• The mixture is already formulated to achieve the best results - just apply it right out of the can and fill up the back of your project . The product makes the filling much easier, because it does not stick to typical applicators!
• Then let it dry as normal. Thin layers of up to 1 cm or 3/8'' only take 1-2 hours to dry, while thicker layers should be left to dry over night. The drying time can be shortened dramatically with heat - taking care that the leather is not damaged, of course.

Disclaimers

• free of Toluene and MEK.
•  Long shelf-life
• consistent formulation: no difference between each batch as with selfmade putty
• This product will not work properly if frozen.
• Cannot be shipped to: Iceland, Sardinia, Croatia, Cyprus, Greece, Israel, Malta, Moldova, Morocco, Russia, Serbia, Tunisia, Ukraine.